
You drop your phone on a pad and it charges. Somewhere in New Mexico, a laser pushed 800 watts across 8.6 km of desert air. Both count as wireless power, yet they have almost nothing in common. Here is how the family works, and which parts you can buy.
The short answer: Nearly all wireless power you can use today is a magnetic field crossing a gap of a few millimetres, from a charging pad or a plate under a car. Sending useful power across a room by radio is real but tiny, measured in milliwatts. Beaming kilowatts across kilometres is a lab and military demonstration, not a product.
Inductive charging: a transformer with the middle cut out
A charging pad holds a coil of wire. Push an alternating current through it and you get a magnetic field that flips back and forth. Put a second coil close by, inside the phone, and that changing field induces a current. That is a transformer, except the iron core is replaced by air and a sheet of phone glass.
Air is a poor magnetic path, so the coils must be close and lined up. Classic Qi pads run at 87 to 205 kHz and started at 5 W; later profiles reached 15 W. Qi2 added a ring of magnets so the coils snap into alignment, and moved to 360 kHz. The Wireless Power Consortium says there are now over 13,000 Qi certified products.
The newest step is Qi2 25W, launched as Qi v2.2.1 on 23 July 2025. The consortium said it delivers nearly 70% more power than the original 15 W Qi2 from November 2023, and that over 1.5 billion Qi2 devices shipped within a year of Qi2 arriving. Our Qi2 25W guide explains why many phones still stop at 15 W.
Resonance: the trick that stretches the gap
Tune both coils to the same frequency and energy hops between them far more willingly, like pushing a swing at exactly the right moment. In 2007 an MIT team lit a 60 W bulb from seven feet away using two resonant copper coils. Non-resonant induction over that distance would have been almost a million times less efficient.
That experiment became WiTricity and, eventually, fed into the car industry's wireless charging standard. SAE J2954 covers pads that charge a parked electric car at up to 11 kW with efficiency up to 93% across the ground clearance of a normal car. A 500 kW version for buses and trucks is being written.
Radio and laser: real distance, very different power
Once you leave the magnetic near field, you are broadcasting. Radio spreads in every direction, so a receiver catches a tiny slice. In 2018 the FCC certified Powercast's PowerSpot: a 3 W transmitter at 915 MHz that tops up earbuds within two feet and low-power sensors up to 80 feet. Energous's matching receivers output about 100 mW. Good for sensors, hopeless for phones.
Lasers and microwaves can be aimed, which is why the records belong to them. In May 2025 DARPA's POWER programme delivered more than 800 W for 30 seconds over 8.6 km, onto a receiver of photovoltaic cells behind a mirror. Efficiency from laser to electricity passed 20% at shorter distances; DARPA did not publish the figure for the full range.
Space is the dream. In 2023 Caltech's SSPD-1 satellite beamed microwaves between arrays a foot apart in orbit and lit two LEDs, and a rooftop in Pasadena detected its signal from space. Detected, not powered: no power level for the ground receiver was reported.
| Method | Gap | Typical power | Where you meet it |
|---|---|---|---|
| Inductive (Qi, Qi2) | Millimetres | 5 to 25 W | Phones, earbuds, toothbrushes |
| Resonant (SAE J2954) | Car ground clearance | Up to 11 kW | Electric cars, buses, robots |
| RF radio (Powercast, Energous) | Up to tens of feet | Milliwatts | Sensors, tags, hearing aids |
| Laser or microwave beam | Kilometres | Hundreds of watts | DARPA and university tests |
The cost nobody prints on the box
Every gap wastes energy. Measurements reported by Engadget in June 2026 put Apple's MagSafe at about 36% more electricity than a cable, with 20 to 30% of the input leaving as heat, and misalignment on a plain pad able to halve efficiency. That heat is also why a hot phone quietly slows its wireless charge, which matters if you follow the advice in our 80% charging guide.
What is real and what is hype
- A pad or magnetic puck that charges your phone: real, cheap, and faster than ever with Qi2 25W, if phone, puck and adapter all qualify.
- A floor plate that charges a parked car: real and standardised, but still rare on showroom cars, so check the specific model.
- A box that charges a phone across the room: not a product you can buy. Room-scale radio power is milliwatts for sensors.
- Power beamed from space to your city: a funded research goal. Energy has been beamed in orbit and detected on Earth, nothing more yet.
Frequently asked questions
Is wireless charging safe to sleep next to?
A Qi pad only transmits when a certified receiver is on it and negotiates power, and the field drops off sharply with distance. The real hazard is heat under a thick case or a loose coin, which the standard's foreign-object detection is there to catch. Keep the pad bare and off the bed.
Why does my Qi2 phone charge slower than the puck's rating?
The phone's receiver sets the ceiling, not the puck. A 25 W puck on a 15 W phone gives 15 W; a weak wall adapter or a warm battery cuts it further. Match all three and the consortium says you should see 0 to 50% in about 30 minutes.
So the practical rule for 2026: buy the magnet, not the marketing. A Qi2 25W puck with a 30 W or better adapter is the best wireless power most people will own this decade. Everything beyond a few millimetres is either a sensor trickle or a record attempt.
Conversation
Have a question or correction? Contact Rvasus.